4 SAFETY RULES FOR MAINTENANCE AND ADJUSTMENT
1. Before any maintenance or adjustments to the machine, the motor must be turned off.
Always remove the key from the ignition and turn the main switch to the OFF position
(in order to prevent the motor from starting unexpectedly).
2. Make sure the machine is turned off completely before carrying out any maintenance or
adjustments.
3. Hydraulic machinery:
a. The machine's hydraulic machinery may only be used for its intended purpose, and
maintenance and repairs may only be carried out by persons with knowledge of
hydraulic machinery (including dangers associated with exposure to hydraulic
fluid, in particular when it is under pressure).
b. Without prior agreement with the seller, importer or Timan A/S service
department, adjusting/changing the factory settings of the relief valves is
prohibited.
c. Liability for damages will not apply to damages caused by improper use or
improper maintenance/repair.
d. The used hydraulic components must comply with the rules and standards adopted
by the technician.
e. Before each use, check if the hoses are damaged (cracks, ruptures, inapt
entanglement etc). Replace them immediately if they are damaged. Protect quick
couplings from the ingress of water and dirt when they are not connected.
Note: Never try to find a leak in the hydraulic system by hand (with your hands) -
hydraulic fluid under high pressure escaping from small leaks may not be visible
and even a fine drop of oil can cause hand injuries. Use a piece of wood,
cardboard etc.
4. Radiator:
Never unscrew the radiator cap when the radiator is hot. Hot water may spurt out.
To Next Page
Loading...