Reset
In the highly unlikely event that your UltraSync BLUE becomes
unresponsive and you cannot access the menus, you should try a
reset:
1. Press and hold the Up and Down buttons at the same time for
10 seconds . Do not worry if the screen flickers a little as you hold
the buttons down - this is normal.’.
2. Keep the Up and Down buttons pressed down until the
UltraSync BLUE appears to switch off.
3. Release the Up and Down buttons. The UltraSync BLUE restarts.
When the UltraSync BLUE restarts, it still has all of the settings that
were in place before you reset it. If it is still unresponsive, try
performing a factory reset. A factory reset will restore your UltraSync
BLUE's original settings so any existing settings will be lost (see
Restore Factory Settings on page 52).
UltraSync BLUE User Guide 51
To Next Page
Loading...