TMQ AP4 - General Information - Drive Units

TMQ AP4 Autopilot (AP4S10) 41 of 62 Version 4.96 9/10/2017
General Information - Drive Units
The AP4 autopilot is capable of controlling reversing hydraulic pumps,
mechanical drives, linear hydraulic drive systems, linear mechanical systems,
solenoid valves on constant running pumps and relays
When installing any drive system, refer to the manufacturers’ specifications and
instructions. Follow all instructions.
Installation Considerations
Mechanical Drives
 Ensure correct voltage of drive unit
 Mount horizontally in a dry position
 Ensure robust and stable mounting platform is available
 Provide for cable connection to AP4 control unit
 Provide access for drive sprocket and chain to be fitted
 Provide for cable lay if linear mechanical drive
 Check correct sprocket ratio for the boat
Hydraulic Pumps
 Check correct pump voltage for boat
 Ensure correct flow rate of pump matched for steering
 Mount horizontally in a dry position
 Pump should be mounted lower then the helm pump
 Provide adequate space for hydraulic line connections
 Ensure access to existing boat steering lines
 A balance line must be connected from autopilot pump reservoir to
helm pump reservoir
 Replace any vented bung on pump with non vented
 Check if extra lock valve is needed for steering system
 When mounted, fill with oil and purge air from system