TMQ AP4 - Autopilot Operation Modes; Autopilot Operation - Standard

TMQ AP4 Autopilot (AP4S10) 5 of 62 Version 4.96 9/10/2017
This autopilot can control the movement of the rudder through a mechanical
drive motor, reversing hydraulic pump, solenoid valves on a constant running
pump or relays. The motor outputs have been carefully designed to work with a
wide range of motors - for more information, consult your dealer or TMQ
Electronics.
 The autopilot unit should be installed out of direct sunlight and protected
from water and spray.
 The compass must be installed in a place free of magnetic interference,
and connected to the autopilot.
 The rudder feedback must be attached to the rudder in such a way that it
can accurately measure the position of the ships rudder and is also
connected to the autopilot.
Provision has been made for two standard remotes, either hand remote or
steering lever. Alternatively one active remote can be used. The special remote
mode of operation may have to be adjusted for the various control devices.
Extra devices may be connected via the internal connection strip, for example,
GPS compass heading input.
For more information on installation of your AP4 autopilot, see the
Installation of Autopilot section of this manual.
For more information on using your AP4 autopilot, see the Autopilot
Operation section of this manual.
All control units operate on 12 or 24 volts DC. Electrical cables are supplied for
interconnection of equipment. Hardware is supplied to mount and couple the
mechanical drive unit into the steering system. Hydraulic installation kits can be
supplied (optional at extra cost) if the pipe size and brand of hydraulic system is
specified.
Autopilot Operation - Standard
The following is a brief overview of the capabilities of the AP4 autopilot. Each
is described in more detail later in following pages.