26
- The compressor ratio for each channel is indicated as a numerical value on the Compressor
Ratio button. Clicking the button enables you to make a selection from the dropdown menu. You
can also make changes by clicking the spin button on the right.
- The compressor sync for each channel is indicated as a numerical value on the Compressor
Sync button. Clicking the button enables you to make a selection from the dropdown menu.
- The compressor attack time for each channel is indicated as a numerical value on the
Compressor Attack button. Clicking the button enables you to make a selection from the
dropdown menu. You can also make changes by clicking the spin button on the right.
- The compressor release time for each channel is indicated as a numerical value on the
Compressor Release button. Clicking the button enables you to make a selection from the
dropdown menu. You can also make changes by clicking the spin button on the right.
- The gate threshold level for each channel is indicated as a numerical value on the Gate
Threshold button. Clicking the button enables you to directly input a numerical value. Using the
spin button on the right, you can move the numerical values up or down in increments of 1 dB.
- The gate attack time for each channel is indicated as a numerical value on the Gate Attack
button. Clicking the button enables you to make a selection from the dropdown menu. You can
also make changes by clicking the spin button on the right.
- The gate release time for each channel is indicated as a numerical value on the Gate Release
button. Clicking the button enables you to make a selection from the dropdown menu. You can
also make changes by clicking the spin button on the right.
To Next Page
Loading...
Need help?
General
