EasyManua.ls Logo

TOHATSU BFT 75A - Propeller Service

TOHATSU BFT 75A
168 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
139
MAINTENANCE
1. Disconnect the fuel line from fuel
tank.
2. Empty the tank, pour in a small
quantity of
gasoline, and clean the
tank thoroughly by shaking it.
Drain and dispose of the gasoline
properly.
<Tank Filter Cleaning>
1. Remove the four 5 mm screws
using a flat screw
driver, then
remove the fuel hose connector and
fuel tank filter from the tank.
2. Clean the filter in nonflammable
solvent. Inspect
the fuel tank filter
and the connector gasket. Replace
them if damaged.
3. Reinstall the filter and hose
connec
tor in the fuel tank. Tighten
the four 5 mm screws securely.
EMISSION CONTROL SYSTEM
The combustion process produces
carbo
n monoxide and hydrocarbons.
Control of hydrocarbons is very
important because under certain
conditions, they react to form
photochemical smog when subjected
to sunlight. Carbon monoxide dose
not react in the same way, but it is
toxic.
Problems that May Affect Outboard
Motor Emissions
If you are aware of any of the
following symptoms, have the
outboard
motor inspected and
repaired by your authorized
TOHATSU dealer:
1. Hard starting or stalling after
starting
2. Rough idle
3. Misfiring or backfiring during
ac
celeration
4. Poor performance (driveability)
an
d poor fuel economy
5 mm SCREWS CONNECTOR
GASKET
FUEL TANK
FILTER JOINT
(Fuel Hose Connector)
FUEL TANK
FILTER

Table of Contents