TOHATSU BFT 75A - Trimming the Outboard Motor

95
OPERATION
1. Press the DN (down) of the power
trim/tilt switch and trim the
outboard motor at the lowermost
position.
R3 type:
When the two outboard motors are
mounted:
1)Press the DN (down) of the power
trim/tilt switch on the control lever
and trim the outboard motors at the
lowermost position.
2)With the outboard motors trimmed
at the l
owermost position, adjust
the trim angle of the right and left
outboard motors using the switch
on the control lever simultaneously.
Cruising (R type)
(R1 type)
POWER TRIM/
TILT SWITCH
POWER TRIM/
TILT SWITCH
(R2 type)
LOWERMOST
POSITION
(R3 type)
(single type)
(dual type)
POWER TRIM/
TILT SWITCH
POWER TRIM/TILT SWITCH
(LEFT) (RIGHT)