TOHATSU BFT 75A - SAFETY; Safety Information

CONTENTS
4
1. SAFETY ............................................................................................7
SAFETY INFORMATION............................................................7
2. SAFETY LABEL LOCATIONS.................................................... 10
3. COMPONENT IDENTIFICATION ...............................................13
4. CONTROLS AND FEATURES .....................................................21
H type
Engine Switch (Ignition Switch).............................................21
Shift Lever...............................................................................21
Throttle Grip............................................................................22
Throttle Friction Adjuster .......................................................22
Emergency Stop Switch ..........................................................23
Emergency Stop Switch Lanyard/Clip....................................23
Steering Friction Adjusting Knob ........................................... 24
R type
Remote Control Lever.............................................................25
R1 type ................................................................................25
R2 type ................................................................................26
R3 type ................................................................................27
Neutral Release Lever ............................................................28
Engine Switch (Ignition Switch) ............................................28
Fast Idle Lever/Fast Idle Button..............................................29
Emergency Stop Switch ..........................................................30
Emergency Stop Switch Lanyard/Clip....................................30
Spare Emergency Stop Switch Clip ........................................31
TRL (Trolling) Control Switch Panel (optional
equipment)...32
T type
Power Trim/Tilt Switch ..........................................................33
Trim Meter (equipped type or optiona
l equipment) ...............34
Power Tilt Switch (outboard motor pan) ...............................34
Manual Relief Valve ...............................................................35
Common
Tilt Lock Lever ....................................................................... 36
Oil Pressure Indicator/Buzzer................................................. 36
Overheat Indicator/Buzzer...................................................... 37
ACG Indicator/Buzzer............................................................ 38
PGM-FI Indicator/Buzzer ...................................................... 39
Water Separator Buzzer ......................................................... 39
Trim Tab ................................................................................. 40
Anode......................................................................................
40
Cooling Water Intake Port ...................................................... 41
Cooling Water Check Hole .................................................... 41
Engine Cover Fixing Lever .................................................... 42
Tachometer (equipped type or
optional equipment)............... 42
Fuel Filler Cap (equipped type).............................................. 42
Fuel Gauge.............................................................................. 43
Fuel Line Connector And Joint (equipped type)
.................... 43
NMEA Interface Coupler .......................................................
44
Operating Hour Notification System ...................................... 44
5. INSTALLATION............................................................................ 47
Transom Height ........................................................................... 47
Location ....................................................................................... 48
Installation Height ....................................................................... 48
Outboard Motor Installation ........................................................ 49
Outboard Motor Angle Inspection (Cruising) ............................. 50
Battery Connections..................................................................... 51
Remote Control Installation (equipped
type or optional
equipment) .............................................................................. 53
Remote Control Box Location................................................ 54
Remote Control Cable Length ................................................ 54
Propeller Selection....................................................................... 55