TOMAHAWK TW-9010
ATTENTION!
Remote engine start-up cannot be done in the case if:
1. Gear lever is not in neutral position.
2. Ignition switched ON.
3. The hood is open.
4. The hand-brake is not engaged.
In any of these occasions, siren will sound 4 “CHIRPS” at a remote start-up attempt.
13. Remote Engine Stop
In the case when the engine was started using remote start-up, you can stop it by pressing button
. Parking lights will flash 4 times; siren will sound 4 “CHIRPS”. LCD will hide icon and
a melody will play.
14. Warming-up Engine to Specified Temperature
Tomahawk provides for an auxiliary temperature sensor for installation under the hood (see
Diagram No.10). If this sensor is installed, engine start and warm-up is performed by this sensor’s
data, otherwise by the cabin temperature sensor data.
To enable this function, press and hold buttons and simultaneously. Parking lights
will flash 1 time and siren will sound 1 “CHIRP” to confirm enabling the function. LCD will display
icon and the specified temperature for warm-up switch-on (programmable, see Programming
Table) accompanied with a melody. When temperature reaches the specified value for automatic
warm-up switch-on, the engine will start for previously programmed time (see Programming Table).
9
To Next Page
Loading...