TOMAHAWK TW-9010
3. Wire Connections
6 PIN Remote Start-up Power Socket
1. Black and yellow wire – starter switch-on wire (+12V).
This is an output signal +12V to starting relay.
It is connected to ignition lock wire where +12V appears in the “Starter” key position. This
signal is for engine start-up. Connect this wire to blocking relay.
2. Blue wire –An output signal +12V ACC – auxiliary equipment.
It is connected to ignition lock wire where +12V appears in the “ACC” and “Ignition ON” key
position.
3. Thin red wire – system power supply wire (+12V)
It is connected to ignition battery “+” terminal via 10A fuse.
4. Thick red wire – remote start-up circuit power supply wire (+12V)
It is connected to ignition battery “+” terminal via 40A fuse.
5. Yellow wire – IGN 1 wire, output signal +12V.
It is connected to ignition lock wire where +12V appears in the “Ignition ON” key position and
does not disappear in the “Starter” position.
6. Green wire - IGN 2 wire, output signal +12V.
It is connected to ignition lock wire where +12V appears in the “Ignition ON” key position and
disappears in the “Starter” position, if this wire is available on the vehicle where the system is
installed.
24
To Next Page
Loading...
General