TOMAHAWK TW-9010
On triggering the shock sensor main zone (strong shock), the system will enable alarm mode for
25 sec. LCD will display icon and an alarm signal will sound.
On triggering any other zone, the system will enable alarm mode for 30 sec. LCD will display an
icon corresponding to the triggered zone (see page 3) and an alarm signal will sound.
ATTENTION!
To disable the alarm signal, press button . This will cut the alarm mode off but the car will remain
secured.
22. “Panic” Mode
To enable this function, press and hold buttons and simultaneously, engine must not be
started. Parking lights will flash 3 times and siren will sound 3 “CHIRPS” to attract attention to your
car.
23. “Anti-Hijack” Mode
To enable this function, press and hold buttons and simultaneously. Parking lights will
flash for 30 sec, then the system will enable alarm mode, engine starter will be locked. LCD will
display icon and an alarm signal will sound.
To disable this mode, press button .
This mode can be also enabled using button “Anti-hijack”. Press button “Anti-hijack” (car
engine must be started). Parking lights will blink for 30 sec, after which the system will enable
alarm mode, engine starter will be locked. This mode will not be disabled before button is
pressed. You can also exit this mode by holding button “Anti-hijack” for 5 sec.
24. “Valet” Mode
To enable this function, press and hold buttons , and simultaneously. Parking
lights will flash 4 times and siren will sound 4 “CHIRPS” to confirm Valet mode enabling. LCD
will display icon , and a melody will play.
12