EasyManuals Logo

Tomahawk TW-9010 User Manual

Tomahawk TW-9010
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
TOMAHAWK TW-9010
35. Description of Programmable Functions
1. Time allotted for engine running after remote start-up: 5/10/15/20 min.
2. Engine temperature when automatic warm-up is switched ON (if the function is enabled): -5
o
/
-10
o
/-20
o
/30
o
C.
3. Time for starter operation when remote start-up function is enabled: 800/1200/1800/3000 ms.
Time for the first start-up attempt is specified. If first attempt fails, the system will increase time
for each three subsequent attempt by 200 msec.
ATTENTION!
Set starter operation time for 3000 msec only when engine operation is controlled by tachometer.
4. Engine operation control versions:
Version 1 – by vehicle network voltage.
Version 2 – by oil pressure sensor.
Version 3 – by tachometer.
ATTENTION!
If you choose 3rd version of engine operation control, it is necessary to program idle run RPM
as follows:
1. Disconnect all power users on the vehicle (such as conditioner, radio and tape recorder,
amplifier).
2. Switch ignition ON and press button OVERRIDE 9 times.
3. Switch ignition OFF. Siren will sound 9 “CHIRPS” and LED will give 9 flashes. Wait for
the LED to glow.
4. Start engine with ignition key.
5. After engine speed reaches 500-1500 RPM and the engine is warmed enough, go to the next
step.
6. Press and hold button OVERRIDE 1 time. If the procedure is successful, the system will
sound 1 “CHIRP”, otherwise it will alert with 4 “CHIRPS” of the necessity to repeat the
procedure.
20

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tomahawk TW-9010 and is the answer not in the manual?

Tomahawk TW-9010 Specifications

General IconGeneral
BrandTomahawk
ModelTW-9010
CategoryCar Alarm
LanguageEnglish