1-3
䕔
- A magnet is built into the instrument. Do not place any electronic device,
magnetic card, and other objects that may be affected by magnetism
near the instrument. These may become unusable.
䕔
Precautions before operation
- Check the electrical contact of switches, polarity, dial setting, and
meters, and that the instrument is working correctly.
- Check that all cables are connected correctly.
- Do not allow water or chemicals to splash on measurement probes,
except for the tips. Any water or chemicals entering the probes may
cause an electric shock or failure.
- Check the sections that the patient will directly touch.
- Check that the date set in the instrument conforms to the actual
operation date and time.
䕔
Precautions during operation
- Do not place any container with liquid in it on the instrument. Any liquid
entering the instrument may cause electric shock or failure.
-
Be sure to touch the “New” button on the main unit to delete the
measurement data for the previous patient before measuring a new
patient. If new measurement is started without deleting the previous
data, the measurement data for the previous patient may be included.
- Do not allow the patient to touch the terminals for connecting the
instrument to external devices.
- Do not press on the instrument from the top. Doing so may cause
failure of the instrument.
- Do not allow water or chemicals to splash on probes, except for the tips.
Any water or chemicals entering the probes may cause an electric
shock or failure.
- Be extremely careful not to take too much time or too many
measurements, as this can stress the patient.
To Next Page
Loading...
Need help?
General
