11.
Route bar. The route bar is shown when you have planned a route.
The guidance view
The guidance view is used to guide you along the route to your destination. The guidance view is
shown when you start driving. You see your current location and details along your route, including
3D buildings in some cities.
T
he guidance view is normally in 3D. To show a 2D map with the map moving in your direction of
travel, change the 2D and 3D default settings.
When your TomTom GO CLASSIC starts after sleeping and you have a route planned, you are shown
the
guidance view with your current location.
1.
Switch view button. Select the switch view button to change between the map view and the
guidance v
iew. When in guidance view, if you are driving, the small arrow rotates to indicate
your d
irection of travel relative to north, with north being up.
2.
Zoom buttons. Select the zoom buttons to zoom in and out.
3.
Instruction panel. This panel shows the following information:
The direction of your next turn.
The distance to your next turn.
Tip: On some devices you can also pinch to zoom in and out.
Tip: When you have planned a route and the 3D guidance view is shown, select the switch view
button to change to the map view and use the interactive features.
Note: 3D buildings in guidance view are not available on all devices.
To Next Page
Need help?
General
Weight and Dimensions
