TomTom GO CLASSIC User Manual

9
Get going
Installing in your car
Use the supplied mount to install your TomTom GO CLASSIC in your vehicle. Read the
instructions about positioning your device before you install your TomTom GO.
To install your TomTom GO, do the following:
1. Connect the supplied USB cable to the mount. If the mount is integrated into your TomTom GO,
connect the USB cab
le to the device.
2. Connect the USB cable to the USB car charger and plug this into the power supply on your
dashboard.
3. Choose the best smooth location, on your windscreen or side window, to mount your TomTom
GO CLASSIC.
4. Make sure that both the suction cup on the mount and your windscreen are clean and dry.
5. Press the suction cup of the mount firmly against your windscreen.
6. Turn the rubber grip near the base of the mount in a clockwise direction until you feel it lock.
7. If your mount is not integrated into your TomTom GO, place your TomTom GO in the mount,
making sure th
at it clicks into place.
Dashboard adhesive disks are available as part of a range of accessories for your TomTom GO. For
more information, go to tomtom.com/accessories.
Positioning your TomTom GO CLASSIC
Be careful where you install your TomTom GO CLASSIC. The TomTom GO shouldn't block or
interfere with any of the following:
 Your view of the road.
 The controls in your vehicle.
 Your rear-view mirrors.
 The airbags.
You should be able to reach your TomTom GO easily without leaning or stretching. In a car, you can
attach your TomTom GO to the windscreen or side window or you can use a Dashboard Mount Disk to
attach the mount to your dashboard.
Switching on and off
Sw
itching your device on
Press the On/Off button until your device starts. If the device was off you see the map view. If your
device was sleeping you see the last screen you were looking at.
Tip: If the mount is integrated into your TomTom GO, you can easily change the rotation of
your device. Release the mount from the TomTom GO using the thumb indent. Turn the mount
around and clip it back onto the device until you hear it click.
Note: Use ONLY the USB cable supplied with your TomTom GO. Other USB cables may not
work.

TomTom GO CLASSIC Specifications

General

Display diagonal	5 \
Touch technology	Multi-touch
Display resolution	480 x 272 pixels
Placement supported	Horizontal/Vertical
Spoken languages	- Afrikaans - Arabic - Australian English - Bulgarian - Catalan - Croatian - Czech - Danish - Dutch - Dutch Belgium - Finnish - French - German - Greek - Hungarian - Irish English - Italian - Lithuanian - New Zealand English - Norwegian - Polish - Portuguese - Portuguese Brazil - Serbian - Slovenian - Spanish - Spanish (Latin American) - Spanish Argentina/Latin - Spanish Chile - Swedish - Turkish - UK English - US English
Languages support	Multi
Traffic Message Channel (TMC)	-
Cables included	USB
Marine (chartplotters, sounders)	No
Battery type	Built-in
Power source type	Battery
Battery life (max)	1 h
Storage media type	Flash
Compatible memory cards	MicroSD (TransFlash)
Included memory card size	32 GB
Internal storage capacity	16 GB
Form factor	Fixed
Product color	Black
Map coverage	All Europe

Weight and Dimensions

Depth	23.8 mm
Width	162.5 mm
Height	104.8 mm
Weight	201 g