Planning a route using coordinates using step by step search
ST
EP BY STEP SEARCH ONLY
Important: In the interest of safety and to avoid distractions while you are driving, you should
always plan a route before you start driving.
To plan a route using a pair of coordinates, do the following:
1.
Select the Main Menu button to open the Main Menu.
2.
Select Drive To.
3.
Select Latitude Longitude.
4.
Type in your pair of coordinates. You can enter any of these coordinate types:
 Decimal values, for example:
N 51.
51000 W 0.13454
51.51000
-0.13454
 Degrees, minutes and seconds, for example:
N 51
°30′31″ W 0°08′34″
 GPS standard coordinates, for example:
N 51 30.
525 W 0 08.569
5.
As you type in the coordinates, suggestions are shown based on what you have entered. You can
continue ty
ping or select a suggestion.
6.
Select a suggestion for your destination.
The l
ocation is shown on the map.
7.
To plan a route to this destination, select Drive/Ride depending on which device you are using.
A route is planned and then guidance to your destination begins. As soon as you start driving,
the g
uidance view is shown automatically.
Tip: To see more results, hide the keyboard or scroll down the results list.
Tip: You can switch between seeing the results on the map or in a list by selecting the
list/map button:
Note: The bar below the coordinates goes red if you enter coordinates that are not
recognised
by your TomTom GO CLASSIC.
Tip: For decimal values you don't have to use a letter to indicate the latitude and longi-
tude. For locations west of the 0 meridian and locations south of the equator, use a minus
sign (-) before the coordinate.
Tip: The example coordinates shown on the screen are your current latitude and longitude.
To Next Page
Need help?
General
Weight and Dimensions
