ToolKitRC M8 - Signal Measurement: PPM and sBus; sBus Signal Characteristics; PPM Signal Measurement Interface; sBus;xBus Signal Measurement

@
ToolkitRC
2019
22
identify and switch to the corresponding interface.
2, sBus is an inverted signal, baud rate 100kbps 8-bit
data bit ,2-bit stop bit, even parity
=================================
Rotate the Knob switchon the measurement main
interface to move the cursor to the [PPM] item, press
[OK] to enter the PPM test interface as shown below.
Rotate the Knob to move the cursor to the [xBus]
item, press [OK] to enter the compatible signal test
of SBus, Dbus, etc., rotate the Knob , and switch the
16 channel value and status bit. The display interface
is as follows 2 (9-16 channel display is omitted)