ToolKitRC M8 - Signal Measurement; Signal Type Selection; PWM Signal Measurement; PWM;PPM Signal Identification

@
ToolkitRC
2019
21
=================================
Signal measurement
After selecting the [Measurement] function on the
main interface, press [OK] to enter the function and
display the following interface. Turn [Jog] to select
the type of signal to be tested.
Rotate the Jog to move the cursor to the [PWM]
item, press [OK] to enter the PWM test interface as
shown below.
=================================
Tip:
1, PWM and PPM signals can automatically