19
OPERATION OF Ez Capture for DC-4
OPERATION OF Ez Capture for DC-4
Photography Startup
Click the [Slit] button circled with red frame on "Startup Screen", and "DC-4 Grabber (Photography
screen)" starts. For details of DC-4 Grabber, refer to "Details of DC-4 Grabber (Photography screen)".
The ID input screen may appear before DC-4 Grabber is started or after photography is completed.
Setting of timing for starting the ID input screen is made in [Options] under "Setup of Ez Capture".
NOTES
Before starting photography, make sure that the free capacity of the hard disk is
sufficient.
If the capacity is not sufficient, the system may not operate normally.
DC-4 Grabber (Photography screen)
To Next Page
Loading...
