Topcon DL-503 - Page 65

64
Other Procedures
3 Charging takes approximately 2.5 hours.
The lamp lights when charging is finished.
4 Remove the battery and unplug the charger.
• Slots 1 and 2
• Step 2: The charger starts charging the battery mounted
first. If you place two batteries in the charger, the
battery in slot 1 is charged first, and then the
battery in slot 2.
• Charging lamp
• Steps 2 and 3: The charging lamp is off when
•The charger is outside the charging temperature
range.
•The battery is mounted incorrectly.
If the lamp is still off after the charger falls within
its charging temperature range and the battery is
mounted again, contact your local dealer.
Notes:
DL502-503.book 64 ページ ２０１０年４月５日 月曜日 午前９時４７分