78
Specifications
DL-503:
Electronic Measurement
0.8mm (0.03in.) (with BIS20/30)
1.5mm (0.06in.) (with BGS40/50/50G)
1.7mm (0.047in.) (with BAS55)
Visual Measurement
2.0mm (0.08in.) (with BGS40/50/50G)
2.5mm (0.06in.) (with BAS55)
Distance ±10mm (less than 10m measurement)
±(0.1% x D) (10 to 50m measurement)
±(0.2% x D) (more than 50m measurement)
(D: measured distance, unit: m)
Measuring modes: Single / Repeat / Average / Tracking /
Wave-and-Read
(selectable)
Measuring time:*2
Single
/
Repeat approx. 2.5 sec.
Average No. of measurements set
x approx.
2.5
sec.
Tracking
approx.
1 sec.
Automatic compensator: Magnetic damping and pendulum
mechanism
Compensation range: ±15′
Wave-and-Read
Recommended brightness level for measurement
150 lx or more
Recommended speed for waving of staff
0.5Hz (3 passings of the staff through the
vertical position in 3 seconds)
Measuring range
Waving angle:5 to 10
° either side of the vertical position
Height : 0.5 to 4m
Distance: 5 to 50m
Recommended staff*3: BGS series
BAS55 (up to heights of 3m)
*1 When measuring outdoors with minimal atmospheric motion,
the staff set up in natural sunlight and luminosity at the surface
of the staff equal to 20lx.
*2 When measuring to a staff set up outdoors in fine to cloudy
conditions.
*1, 2 These specifications may change depending on the weather
conditions and measurement conditions.
DL502-503.book 78 ページ ２０１０年４月５日 月曜日 午前９時４７分
To Next Page
Loading...
