Topcon RL-100 2S User Manual

17
1) The working range of the remote controller is up to a distance of about 300 m from
the instrument.
2) It is necessary to install batteries when using the remote controller. Install the
batteries by referring to “Maintaining Power Sources” on page 33.
3) The power of the remote controller shuts off automatically after about 60 seconds
when key or leveling operations have been completed (Auto Shutoff Function).
When using it in the temperature -10°C or lower, warm up function will activate and
the power for the remote controller shuts off automatically in about 5 minutes after
warm up is completed.
Press the power switch once to restore power to the remote controller after the auto
shutoff function has been activated.
Common use of RC-400 remote controller
RC-400 remote controller can control plural RL-100 2S. When you are using plural RL-100 2S
at your job site, you can use your RC-400 for the other RL-100 2S unit. Change the channel to
receive the internal data of each RL-100 2S to the RC-400 by operating the RC-400.
This function enables operating of each RL-100 2S, by transmitting and displaying the data of
each unit to the remote controller before operation.
See page 28 for the operation “3) Setting channel”.

Topcon RL-100 2S Specifications

General

Brand	Topcon
Model	RL-100 2S
Category	Laser Level
Language	English