•Get the desired chain tension by adjusting the chain bolts
Installation Overview
Installation of the Opener
Caution:
*Be sure that the opener is installed in a level
and paralleled position. Improper installation
could result in property damage, severe injury,
and/or death.
* Before starting installation, ensure that there is
no point of friction during the entire movement
of the gate and there is no danger of derailment.
* Ensure that the safety side rollers are present.
Necessary Tools: The following tools may be
necessary to install the Gate opener. You will need
screwdrivers, an electric drill, wire cutters and a wire
stripper, a socket set, and possibly access to a
welder.
When install the opener, you should build a
concrete pad to support the base plate of opener in
order to maintain proper stability.
The installation proceeds are as follows:
1. Assemble the Base Plate and fix the Opener to
the Base Plate.
2.Dig a hole for a concrete pad which should be
approximately 60 x 32 x 35cm (24〞x 13〞x 14〞). It
may protrude 10 cm (4”) above ground and 25 cm
(10”) in depth underground. Increase the pad height
if necessary to protect the system from flooding,
To Next Page
Loading...
