Tormach ATC - Page 19

2. Makesurethespindleisiniallyempty.Thereshould
benotoolholderinthespindleatthispoint.
3. Clickthe“GoToTrayLoadPosion”buonontheATC
Setupscreen.TheZaxiswilljogupandthetraywill
actuatein,openingthetoolaccessdoor,andthedraw
barwillactuate.
4. Verifythatthespindleisroughlyinthecenterofthe
carouseldooropening.Ifnecessary,movetheATC
forwardorbackwardbylooseningthefourangenuts
thatholdthesquaretubemounttothecolumn.
5. Insertalong(12-14”)dowelorpieceofroundstock
intoaTTStoolholder.Insertthetoolholderintothe
forkoftheexposedtrayslot.Usingothervercallines
(edgeofmilcolumn,Tslotsintable)sightalongthe
dowelandcheckwhetherthedowelandthespindle
axisareparallelinbothXandYplanes.
6. Ifthedowelandthespindleaxisarenotparallel,
adjusttheltoftheATCinbothXandYdirecons
unltheyare.
• TiltintheYdireconisfacilitatedbylooseningthe
angenutsthatholdthesquaretubemounttothe
column,thengentlytappingtheATCtrapezoidmount
with a mallet.
• TiltintheXdireconcanbeadjustedbyloosening
thesocketheadcapscrewsthatmounttheATCtothe
squaretube,thenturningtheeccentricadjustment
screws.ThisisbestdonewiththeATCinthe“Tray
In”posion,asthecenterofgravityoftheunitin
the“TrayIn”posionwillallowyoutouseboth
adjustmentscrewstolttheATC.
• Verifythatthetoolholdershankisparalleltothe
spindleaxisinbothXandYbyusinganangleblockor
1-2-3blockwithastraightedge:
16
17
UM10081_TTS_ATC_PCNC1100_1013A UM10081_TTS_ATC_PCNC1100_1013A