7
GENERAL RULES OF SAFETY
The rules below have to be followed carefully in
order to avoid injury to the operator and damage
to the machine.
− Read the labels carefully on the machine. Do
not cover them for any reason and replace them
immediately if damaged.
− ATTENTION: The machine must be used exclu-
sively by authorized staff that have been instruct-
ed on its correct and proper use.
− ATTENTION: Do not use the machine on areas
having a higher gradient than the one stated on
the number plate.
− ATTENTION: The machine is not to be used by
persons, children included, with reduced physi-
cal, sensorial or mental capabilities, or with lack
of experience or knowledge, unless they could
benet, through the intermediation of a respon-
sible person for their safety, by a supervision or
instructions concerning to its use.
− During the operation of the machine, pay atten-
tion to other people and especially to the children.
− Children shall not play with the machine.
− Children cannot carry out cleaning and mainte-
nance of the machine.
TRANSFER
− Do not strike shelvings or scaffoldings where
there is danger of falling objects.
− Leaving the machine in parking position, re-
move the key and set the parking brake.
− Do not use the machine as a means of trans-
port.
− Adapt the working speed to the adhesion con-
ditions: particularly, slow down before narrow
curves have to be faced.
STORAGE AND DISPOSAL
− Storage temperature: between 32°F and 131°F
(0°C and +55°C).
− Perfect operating temperature: between 32°F
and 104°F (0°C and +40°C).
− The humidity should not exceed 95%.
− Provide for the scrapping of the material of
normal wear following strictly the respective rules.
When your machine has to stop activity, provide
for the appropriate waste disposal of its materials,
especially oils, batteries and electronic compo-
nents, and considering that the machine itself has
been, where possible, constructed using recy-
clable materials.
CORRECT USE
− Do not use the machine on surfaces covered
with inammable liquids or dusts (for example
hydrocarbons, ashes or soot).
− In case of re, use a powder based re-extin-
guisher. Do not use water.
− Do not use the machine in explosive atmo-
sphere.
− The machine has to carry out simultaneously
the operations of washing and drying. Different
operations must be carried out in restricted areas
prohibited to non-authorized personnel and the
operator has to wear suitable shoes.
− Signal the areas of moist oors with suitable
signs.
− Do not mix different detergents, avoiding harm-
ful odors.
− Avoid pad operation when the machine is
standing still in order to prevent oor damages.
− Before lifting the recovery tank, make sure that
it is empty.
MAINTENANCE
− If the machine does not work properly, check
by conducting simple maintenance procedures.
Otherwise, ask for technical advice from an au-
thorized assistance center.
− For any cleaning and/or maintenance operation
take off the power supply from the machine.
− Where parts are required, ask for ORIGINAL
spare parts from the distributor and/or from an
authorized dealer.
− Do not take off the protections which require
the use of tools for their removal.
− Do not wash the machine with direct water, jets
or with high water pressure nor with corrosive
material.
− Every 200 working hours have a machine
check by an authorized service department. −
Before using the machine, check that all panels
and coverings are in their position as indicated in
this use and maintenance manual.
− Restore all electrical connections after any
maintenance operation.
https://harrissupplyind.com - To Order Parts Call 608-268-8080
To Next Page
Loading...
Need help?
General