Right Section:
The first two settings set the nominal AC and DC voltage for the controller.
Technical information about the controller: Serial Number, Battery Charger Type, Model Name and Software
Revision.
This page will reset the ViZiTouch to the original factory configuration, thus clearing all subsequent configurations
performed during the life of the controller.
This procedure should only be used as a last attempt to bring back the controller to a usable state.
User “Level 2”:
The “RESET” button will be activated (will become blue) only if no square buttons from the left column are activated
and the “Last Saved Settings” from the right column is not activated as well. A “Level 2” user can only reset the
“Factory Settings” and/or the “Additional Settings” from the right column.
The “Factory Settings” reset will restore the controller to its original factory configuration and service state. This
means that the first service will be undone, automatic mode settings, as well as the controller’s “Homepage” will be
deactivated until “First Service” is completed again. Please refer to the “Quick Start-Up” guide for more information
on how to perform the “First Start-Up” and how to complete the “Field Acceptance Test Report”.
Please note that all logs, pump curves and statistics will not be reset.
The “Additional Settings” reset will update the controller with an additional configuration sent by the manufacturer. It
does not perform a true “Factory Reset”. Its purpose is to allow an update of configuration variables that can only be
updated by Tornatech Inc.
All other square buttons on this page are “Level 9” security and can only be used by certified Tornatech
representatives, unless otherwise specified. The first square in the upper left corner performs the “Select all”
function for these parameters.
To Next Page
Loading...
Need help?
General
