tornos DECO 13a - Page 19

QUICK REFERENCE − DECO 13A
en 300417 − 04/08 19
M/SRes
p.
NoteFunctionCode
M172 Enable Z4 servo−lag check (DO1892) no S
M173 Disable Z4 servo−lag check (DO1893) no S
M180 Long parts, forth travel of ejector (DO1980)
M181 Long parts, back travel of ejector (DO1981)
M182 Long parts, forth travel of ejection
actuator
(DO1982)
M183 Long parts, back travel of ejection
actuator
(DO1983)
M184 Long parts, workpiece tilting ON (DO1984)
M185 Long parts, workpiece tilting OFF (DO1985)
M186 Long parts, check ejector forth (DO1986)
M187 Long parts, check ejector on back (DO1987)
M188 Long parts, check ejector actuator
forth
(DO1990)
M189 Long parts, check if ejection actuator
back
(DO1991)
M191 Adjust guidebush (DO1924) no S
M192 Open guidebush (DO1926) no S
M198 Switch S1 spindle to rotary axis mode Disregards
Param. W.
no M
M199 Switch S1 back to spindle mode
speed.
Cancel M198
Disregards
Param. W.
no M