Greensmaster Flex 21Groomer (Model 04204) (Rev. B) Page 9 – 10
10.Position RH groomer arm to front roller, groomer RH
side plate and mower frame. Secure groomer arm to
mower with carriage bolt, washer, and flange nut.
11. Install spring washer and lock nut to secure RH
groomer arm lift rod to RH groomer side plate (Fig. 7).
12.Center front roller and tighten cap screws to secure
roller (Figs. 7 and 8).
13.Reinstall groomer drive belt and belt cover to right
side of mower (see Groomer Belt Replacement in this
section).
14.Lubricate groomer bearings (see Groomer Reel Kit
Installation Instructions).
NOTE: After greasing groomer bearings, operate
groomer for 30 seconds, stop machine and wipe excess
grease from groomer shaft and seals.
15.Check groomer reel height and mower height–of–cut
settings. Adjust as needed.
To Next Page
Loading...
Need help?
General
