Greensmaster Flex 21
Page 6 – 3
Chassis and Controls
Adjustments
Handle Height Adjustment
1. Make sure mower is parked on a level surface with
the engine OFF.
2. Remove hairpin cotters from the ring pins on each
side of the mower handle.
3. Support handle and remove ring pins from each side
of the mower handle. Raise or lower handle to the de-
sired operating position.
4. Align holes. Reinstall ring pins and hairpin cotters.
1. Ring pin 2. Hairpin cotter
Figure 1
2
1
Chassis and
Controls
To Next Page
Loading...
Need help?
General
