Greensmaster Flex 21Page 7 – 6Cutting Unit (Rev. C)
Bearing and Seal Installer (TOR4105)
Used to install bearings and seals into front and rear roll-
ers that have a threaded roller shaft.
NOTE: TOR4105 is an alternative to using washers
and spacers listed above.
Figure 9
Sleeve Driver (TOR4107)
Used to drive the wear sleeve into position on the cutting
reel shaft.
Figure 10
Sleeve Driver and Bearing and Seal Installer Set (TOR4108)
Set includes both TOR4105 and TOR4107 in a plastic
storage case with foam inserts.
Figure 11
To Next Page
Loading...
Need help?
General
