Toro 04042 - Installing the Li+ Diagnostic Wire Harness

InstallingtheLi+Diagnostic
WireHarness
Performthefollowing3shortprocedurestoinstalltheLi+
diagnosticwireharness:
PreparetheMachine
1.Parkthemachineonalevelsurfaceandmovethe
tractionlevertotheNEUTRALposition.
2.RotatethekeyswitchtotheOFFpositionandthen
removethekeyfromtheswitch.
3.Disconnectthebatterypack.RefertoDisconnecting
theBatteryPack(page17).
4.DisconnectthemainwireharnessP34connector
(Figure3).
1
g030573
Figure3
1.MainwireharnessP34connector
RaisetheBatteryPackandDisconnect
theP01Connector
1.Removethenutthatsecurestherearofthebattery
platformtothemachineframe(Figure4).
Figure4
1.Nut
2.Loosenthe2pivotboltsahalfturneach(Figure5).
Figure5
RaisedBatteryPackandPlatform
1.Batterypackandplatform
3.Lockingholes
2.Pivotboltsandnuts
3.Raisethebackofthebatteryplatformuntilthelocking
holesinthefrontofthebatteryplatformandframe
align(Figure5).
4.Inserta6mm(1/4inch)steelrod(e.g.,screwdriver)
throughthelockingholestoholdthebatteryplatform
intheraisedposition(Figure5).
5.Onthebottomofthebatterypack,disconnectthe
batterywireharnessP01connectorbyrotatingthe
lockingcollarcounterclockwiseapproximatelyhalfa
turn(Figure6).
8