Toro 04591 User Manual

• Disabling an equipped 3-Wheel-Drive Kit ; refer
to Disabling an Equipped 3-Wheel-Drive Kit ( page
27 ) .
• Battery-reserve capacity ; refer to Setting the
Battery-Reserve Capacity ( page 28 ) .
Note: Each setting is passcode-protected. Y ou may
need to enter a passcode to edit the settings.
Adjusting the T ap-Off Delay
Navigate to the T APOFF T IME option to adjust the
tap-of f delay . The tap-of f delay feature allows the
cutting units to turn of f without raising. The delay
setting represents the maximum time for the lift/lower
joystick to remain in the rearward position to activate
this feature.
Refer to the following table for the delay time options
and their corresponding increment numbers:
T ap-Off Delay Options
Increment Number
Delay T ime (Seconds)
1
Of f
2 0.050
3 0.100
4 0.150
5
0.200
6 0.250
7
0.300
8 0.350
9 0.400
10 0.450
Note: The factory default setting is 1, which disables
this feature.
Adjusting the Mowing Reel Speed
Navigate to the R EEL S PEED option to adjust the reel
speed while mowing. This setting can be adjusted
when the clip control setting is O FF ; refer to Setting
the Clip-Control Feature ( page 27 ) .
Refer to the following table for the reel speed options
and their corresponding increment numbers:
Mowing Reel Speed Options
Increment Number
Reel Speed (RPM)
1 800
2 950
3 1 100
4 1250
5
1400
Mowing Reel Speed Options (cont'd.)
6 1550
7
1700
8 1850
9 2000
Note: The factory default setting is 2000 rpm
(increment number 9).
Setting the Cutting-Unit Lower
Speed
Navigate to the L OWER S PEED option to set the speed
that the cutting units lower to the ground for mowing.
Y ou can toggle between 1 (slowest speed) and 9
(quickest speed).
T est the lower speed before you mow . Adjust the
speed as desired.
Note: The factory default setting is 5 .
Adjusting the Backlap Reel Speed
Navigate to the B ACKLAP RPM option to adjust the reel
speed while performing a backlap operation.
Refer to the following table for the reel speed options
and their corresponding increment numbers:
Backlap Reel Speed Options
Increment Number
Reel Speed (RPM)
1 200
2 240
3 280
4 320
5
360
6 400
7
440
8 480
9 520
Note: The factory default setting is 200 rpm
(increment number 1).
Adjusting the Clip-Control Feature
Understanding the Radius-Dependent-Speed
(RDS) System
T o achieve a consistent, high quality-of-cut and a
uniform after cut appearance, the machine is equipped
26

Toro 04591 Specifications

General

Brand	Toro
Model	04591
Category	Lawn Mower
Language	English