Toro 30881 - Page 80

g004653
Figure125
1.Cuttingedge3.Wear/slotforming
2.Curvedarea4.Crack
3.Examinethecuttingedgesofallthebladesand
sharpenthecuttingedgesiftheyaredullor
nicked(Figure126).
Note:Sharpenonlythetopofthecutting
edgeandmaintaintheoriginalcuttingangle
toensuresharpness(Figure126).Theblade
remainsbalancedifthesameamountofmetal
isremovedfrombothcuttingedges.
g000276
Figure126
1.Sharpenattheoriginalangle.
Note:Removethebladesandsharpenthem
onagrinder.Aftersharpeningthecuttingedges,
installthebladewiththeanti-scalpcupand
bladebolt;refertoRemovingandInstallingthe
Cutting-UnitBlade(s)(page79).
80