CHASSIS
3-22 Toro Z Master G3 3000/5000/6000 Series Service Manual
3
6. Release the brake cable retainer holding the brake
cable to the cradle. Push the cable through the
routing hole and remove (Fig. 079).
Fig. 079 PICT-8974a
7. Remove the tie strap securing the brake cable to the
cradle (Fig. 080).
Fig. 080 PICT-8977a
A. Right side brake C. Left side brake
assembly assembly
B. Cradle D. Retainer (5)
8. Remove the brake cable from the retainers located
on the cradle (Fig. 081).
Note: The cable is routed around the cradle.
Fig. 081 cables routing #4
9. Remove the cotter pin located on the clevis pin hold-
ing the cable clevis to the brake lever (Fig. 082).
Fig. 082 PICT-8999a
A
B
C
D
D
To Next Page
Loading...
