Toro 74954 - Page 46

CHASSIS
3-25Toro Z Master G3 3000/5000/6000 Series Service Manual
3
5. Route the brake cable into the retainers on the
cradle following the routing diagram (Fig. 091).
Fig. 091 cables routing #4
6. Install the left hand brake cable retainer into the
cradle so that the retainer tab is installed in the slot
on the cradle (Fig. 092).
Fig. 092 PICT-9027a
A. Right side brake C. Left side brake
assembly assembly
B. Cradle D. Retainer (5)
A
B
C
D
D
Fig. 093 PICT-9063a
8. Install the brake cable snap tting into the slotted
bracket (Fig. 094).
Fig. 094 PICT-9065a
7. Slide the brake cable behind the wheel hub and slide
the threaded end of the brake cable through the
trunnion located in the brake caliper (Fig. 093).