CHASSIS
3-61Toro Z Master G3 3000/5000/6000 Series Service Manual
3
13. Secure the front pump linkage assembly to the LH
motion control assembly with a bolt, washer and nut.
Note: The washer must be installed between the LH
motion control assembly and the ball joint on
the front pump linkage assembly (Fig. 216).
Fig. 216 DSCN-4470a
14. Install the two bolts and nuts retaining the LH
steering handle assembly to the LH motion control
lever (Fig. 217).
Fig. 217 DSCN-4459a
15. For adjustments on the control handles and the
motion control neutral lock, see “Adjusting the
Motion Control Neutral Lock Pivot” on page 3-53
and “Adjusting the Control Handle Position” on page
3-53.
17. Start the unit, disengage the park brake lever, and
run for about 5 minutes operating the forward and
reverse handle forward/reverse. Move the motion
control lever to the neutral position and observe the
rear tire for movement. If the rear tire creeps in the
forward position, perform a neutral adjustment. A
slight creep in reverse is allowable. See “Adjusting
the Motion Control Linkage (Neutral Adjustment)” on
page 5-34.
Fig. 218 DSCN-4454a
16. Install the 2 screws retaining the LH motion control
cover assembly (Fig. 218).
To Next Page
Loading...
