ENGINE
4-4 Toro Z Master G3 3000/5000/6000 Series Service Manual
4
15. Remove the bolt, spring washers, and washer
retaining the electric PTO to the engine crankshaft
(Fig. 232). Slide the clutch off the crankshaft.
Fig. 232 DSCN-0031a
16. Remove the engine sheave from the engine
crankshaft (Fig. 233).
Fig. 233 DSCN-0032a
Fig. 231 DSCN-0028a
14. Unplug the wire plug from the electric PTO clutch
(Fig. 231).
13. Using a 1/2” drive breaker bar installed in the square
hole in the pump idler assembly, rotate the pump
idler arm counter-clockwise to relieve tension on the
v-belt (Fig. 230). Remove the v-belt from around the
engine drive pulley.
Fig. 230 DSCN-0025a
To Next Page
Loading...
