ENGINE
4-12 Toro Z Master G3 3000/5000/6000 Series Service Manual
4
25. Install 3 carriage bolts and nuts retaining the LH
bumper to the frame and rear guard (Fig. 261).
Fig. 261 DSCN-0004a
27. Turn the fuel shut off valve to the “On” position; for
tilt seats, lift the seat; for non-tilt seats, slide the seat
forward to access the fuel shut off valve.
28. Lower the machine to the ground with a oor jack,
after removing the jack stands.
29. Install the battery in the frame. Install the positive
and negative battery cables.
26. Install the 3 carriage bolts and nuts retaining the RH
bumper to the frame and rear guard (Fig. 262).
Fig. 262 DSCN-4637a
To Next Page
Loading...
