Toro 74954 - Page 94

ENGINE
4-11Toro Z Master G3 3000/5000/6000 Series Service Manual
4
20. Install the throttle cable in the cable clamp (Fig.
257).
22. Move the throttle arm assembly to the low-idle
position and tighten the throttle cable clamp (Fig.
259).
Fig. 257 DSCN-4253a
Fig. 259 DSCN-4281a
23. Move the throttle control back and forth, checking
the operation of the throttle arm assembly.
24. Install 2 nuts retaining the rear guard to the frame
and 1 carriage bolt nut retaining the mufer guard to
the rear guard (Fig. 260).
Fig. 260 DSCN-0012a
21. Move the throttle control to the slow idle position
(Fig. 258).
Fig. 258 DSCN-4277a