HYDRAULIC SYSTEM
5-3Toro Z Master G3 3000/5000/6000 Series Service Manual
5
10. Raise the rear of the unit and support it with 2 jack
stands placed under the right and left tie down loops
(Fig. 269).
Note: Tires should be at least 6” (15.2cm) off the
oor.
12. Using a 1/2” drive breaker bar installed in the square
hole in the pump idler assembly, rotate the pump
idler arm counter-clockwise to relieve tension on the
v-belt (Fig. 271).
Fig. 269 PICT-8548
11. Remove the two rear wheels (Fig. 270).
Fig. 270 PICT-8550a
Fig. 271 PICT-8557a
13. With tension removed, remove the v-belt from
around the transmission pulleys and the engine drive
pulley (Fig. 272).
Fig. 272 PICT-8561a
To Next Page
Loading...
