HYDRAULIC SYSTEM
5-4 Toro Z Master G3 3000/5000/6000 Series Service Manual
5
16. On the side of the machine being serviced, remove
the cotter pin securing the castle nut to the wheel
hub (Fig. 275).
Fig. 273 PICT-8563
15. On the side of the machine being serviced, pry the
control arm off the square tapered shaft (Fig. 274).
Note: Be careful to not damage the trunnion shaft
seal.
Fig. 274 PICT-8566
Fig. 275 PICT-8578
17. On the side of the machine being serviced, remove
the castle nut from the wheel hub (Fig. 276).
Fig. 276 PICT-8580
14. On the side of the machine being serviced, remove
the bolt and washer securing the hydro control arm
to the hydro drive control shaft (Fig. 273).
To Next Page
Loading...
