Toro GrandStand 71504 - Specifications; Attachments;Accessories

is running. Use these times for scheduling regular
maintenance ( Figure 5 ).
g009467
Figure 5
1. Safety-interlock symbols
3. Hour meter
2. Battery light
Safety-Interlock Indicators
Symbols on the hour meter indicate with a black
triangle that the interlock component is in the correct
position ( Figure 5 ).
Battery-Indicator Light
If you turn the key to the O N position for a few
seconds, the battery voltage displays in the area
where the hours are normally displayed.
The battery light turns on when you turn the key to the
O N position and when the charge is below the correct
operating level ( Figure 5 ).
Choke Control
Use the choke control to start a cold engine. Pull the
choke control up to engage it. Push down on the
choke control to disengage it.
Key Switch
The key switch, used to start and shut of f the engine,
has 3 positions: O FF , R UN , and S TART . Refer to
Operating the Ignition Switch ( page 17 ) .
Motion-Control Levers
Use the motion-control levers to drive the machine
forward, reverse, and turn either direction ( Figure 4 ).
Fuel-Shutoff V alve
Close the fuel-shutof f valve when transporting or
storing the machine; refer to Using the Fuel-Shutof f
V alve ( page 24 ) .
Specications
Note: Specications and design are subject to
change without notice.
48in Mower
Deck
52in Mower
Deck
60in Mower
Deck
122 cm 131 cm 152 cm
Cutting width
(48 inches) (52 inches) (60 inches)
161 cm 172 cm 193 cmWidth with
deector
down
(64 inches) (68 inches) (76 inches)
126 cm 137 cm 158 cmWidth with
deector
raised
(50 inches) (54 inches) (62 inches)
191 cm 191 cm 201 cmLength with
platform
down
(75 inches) (75 inches) (79 inches)
145 cm 145 cm 164 cmLength with
platform up
(61 inches) (61 inches) (65 inches)
122 cm 122 cm 122 cmHeight
(48 inches) (48 inches) (48 inches)
401 kg 405 kg 412 kgW eight
(Non-HD
Models)
(884 lb) (893 lb) (909 lb)
N/A
430 kg 455 kg
W eight (HD
Models)
N/A (949 lb) (1004 lb)
Attachments/Accessories
A selection of T oro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized T oro
distributor or go to www .T oro.com for a list of all
approved attachments and accessories.
T o ensure optimum performance and continued safety
certication of the machine, use only genuine T oro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty .
10