Toro GrandStand 71504 - Greasing the Motion Controls; Engine Maintenance; Engine Safety; Servicing the Air Cleaner

Greasing the Motion
Controls
Service Interval : Y early
Grease the operator-presence-control balljoint and
the motion-control bushing for both levers.
Note: Use an oil drip between the lever brackets to
grease the bushing, located in the pivot tube.
g228034
Figure 37
1. Operator-presence control
balljoint
2. Pivot tube
Engine Maintenance
Engine Safety
• Shut of f the engine before checking the oil or
adding oil to the crankcase.
• Keep your hands, feet, face, clothing, and other
body parts away from the muf er and other hot
surfaces.
Servicing the Air Cleaner
Every 250 hours —Replace the primary air lter
(more often in dirty or dusty conditions).
Every 250 hours —Check the inner air lter
(more often in dirty or dusty conditions).
Every 500 hours —Replace the inner air lter
(more often in dirty or dusty conditions).
Removing the Filters
1. Disengage the PT O, move the motion-control
levers to the N EUTRAL - LOCK position, and
engage the parking brake.
2. Shut of f the engine, remove the key , and wait
for all moving parts to stop before leaving the
operating position.
3. Open the engine guard; refer to Opening the
Engine Guard ( page 29 ) .
4. Release the retaining clamps on the air cleaner
and pull the air-cleaner cover of f the air-cleaner
body ( Figure 38 ).
g026970
Figure 38
1. Air-cleaner clamps
3. Primary lter
2. Air-cleaner cover
4. Inner lter
5. Clean the inside of the air-cleaner cover with
compressed air .
6. Gently slide the primary lter out of the
air-cleaner body ( Figure 38 ).
31