Storage
Storage Safety
• Always shut of f the machine, remove the ignition
key , wait for all moving parts to stop, and allow
the machine to cool before adjusting, servicing,
cleaning, or storing it.
• Let the engine cool before storing the machine.
• Do not store the machine or fuel near ames or
drain the fuel indoors.
Cleaning and Storage
1. Disengage the power takeof f (PT O), engage the
parking brake, shut of f the engine, and remove
the key .
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially
the engine.
Important: Y ou can wash the machine
with a mild detergent and water . Do not
pressure-wash the machine. A void excessive
use of water , especially near the drive system
and engine. Pressure-washing can force dirt
and water into critical parts, such as spindle
bearings and electrical switches.
3. Clean any dirt and chaf f from the outside of the
engine cylinder-head ns and blower housing.
4. Check the brake; refer to T esting the Parking
Brake ( page 44 ) .
5. Service the air cleaner; refer to Servicing the Air
Cleaner ( page 31 ) .
6. Grease the machine; refer to Greasing the
Machine ( page 29 ) .
7. Change the engine oil; refer to Changing the
Engine Oil ( page 33 ) .
8. Check the tire pressure; refer to Checking the
T ire Pressure ( page 40 ) .
9. For long-term storage, do the following:
A. Add fuel stabilizer/conditioner to the fuel in
the tank as directed by the fuel stabilizer
manufacturer .
B. Run the engine to distribute the conditioned
fuel through the fuel system for 5 minutes.
C. Shut of f the engine, allow it to cool, and
drain the fuel tank; refer to Draining the
Fuel T ank ( page 36 ) , or operate the engine
until it shuts of f.
D. Start the engine and allow it to run until it
shuts of f. Repeat with the choke engaged (if
applicable) until the engine does not start.
E. Dispose of fuel properly; recycle it according
to local regulations.
Important: Do not store fuel containing
stabilizer/conditioner longer than
the duration recommended by the
fuel-stabilizer manufacturer .
10. Remove the spark plug(s) and check its
condition; refer to Servicing the Spark Plug
( page 34 ) .
1 1. With the spark plug(s) removed from the engine,
pour 15 ml (2 tablespoons) of engine oil into the
spark-plug hole, and use the starter to crank the
engine and distribute the oil inside the cylinder .
12. Install the spark plug(s) but do not connect the
wire to the spark plug(s).
13. Check and tighten all fasteners. Repair or
replace any part that is damaged or missing.
14. Paint all scratched or bare metal surfaces with
paint from an Authorized Service Dealer .
15. Store the machine in a clean, dry , garage or
storage area. Remove the key from the switch
and store it in a memorable place. Cover the
machine to protect it and keep it clean.
56
To Next Page
Loading...
