Toro GrandStand 71504 - Page 33

2. Shut of f the engine, remove the key , and wait
for all moving parts to stop before leaving the
operating position.
3. Check the engine-oil level as shown in ( Figure
40 ).
g031341
g307458
Figure 40
Changing the Engine Oil
Service Interval : After the rst 8 hours
Every 100 hours
Note: Dispose of the used oil at a recycling center .
1. Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil
drains completely .
2. Disengage the PT O, move the motion-control
levers to the N EUTRAL - LOCK position, and
engage the parking brake.
3. Shut of f the engine, remove the key , and wait
for all moving parts to stop before leaving the
operating position.
4. Change the engine oil as shown in Figure 41 .
g031341
g031447
Figure 41
5. Slowly pour approximately 80% of the specied
oil into the ller tube and slowly add the
additional oil to bring it to the Full mark ( Figure
42 ).
33