Toro GrandStand 71504 - Replacing the Fuel Filter; Electrical System Maintenance; Electrical System Safety; Servicing the Battery

Replacing the Fuel Filter
Service Interval : Every 800 hours/Y early (whichever
comes rst)
Do not install a dirty lter if it is removed from the fuel
line.
Note: Wipe up any spilled fuel.
1. Park the machine on a level surface, disengage
the PT O, and engage the parking brake.
2. Shut of f the engine, remove the key , and wait
for all moving parts to stop before leaving the
operating position.
3. Close the fuel-shutof f valve; refer to Using the
Fuel-Shutof f V alve ( page 24 ) .
4. Replace the fuel lter as shown in .
g027518
Figure 49
Electrical System
Maintenance
Electrical System Safety
• Disconnect the battery or remove the spark-plug
wire before making any repairs. Disconnect the
negative terminal rst and the positive terminal
last. Connect the positive terminal rst and
negative last.
• Charge the battery in an open, well-ventilated
area, away from sparks and ames. Unplug the
charger before connecting or disconnecting the
battery . W ear protective clothing and use insulated
tools.
Servicing the Battery
Service Interval : Every 100 hours
Always keep the battery clean and fully charged. Use
a paper towel to clean the battery case. If the battery
terminals are corroded, clean them with a solution of
four parts water and 1 part baking soda. Apply a light
coating of grease to the battery terminals to prevent
corrosion.
V oltage: 12 V
Removing the Battery
1. Park the machine on a level surface, disengage
the PT O, and engage the parking brake.
2. Shut of f the engine, remove the key , and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the battery as shown in Figure 50 .
37