Using W eights
• Install weights to improve balance. Y ou can add or
remove weights to create optimized performance
under dif ferent operating conditions and for your
preference.
• Add or remove weights 1 at a time until you
achieve the desired handling and balance.
• Refer to the Operator ’ s Manual of attachments for
recommended weights.
Note: Contact an Authorized Service Dealer to order
a weight kit.
W ARNING
Excessive weight changes can affect the
handling and operation of the machine.
This could cause serious injury to you or
bystanders.
• Make weight changes in small increments
only .
• Evaluate the machine after each weight
change to ensure that you can operate the
machine safely .
After Operation
After Operation Safety
General Safety
• Always shut of f the machine, remove the ignition
key , wait for all moving parts to stop, and allow
the machine to cool before adjusting, servicing,
cleaning, or storing it.
• Clean grass and debris from the cutting units,
muf ers, and engine compartment to help prevent
res. Clean up oil or fuel spills.
• Shut of f the fuel before storing or transporting the
machine.
• Disengage the PT O whenever you are transporting
or not using the machine.
• Never store the machine or fuel container where
there is an open ame, spark, or pilot light, such
as on a water heater or on other appliances.
• Use full-width ramps for loading the machine into
a trailer or truck.
• T ie the machine down securely using straps,
chains, cable, or ropes. Both front and rear straps
should be directed down and outward from the
machine.
23
To Next Page
Loading...
