Controls System
Maintenance
Adjusting the
Motion-Control Levers
If the motion-control levers do not align horizontally ,
adjust the motion-control levers.
1. Park the machine on a level surface, disengage
the PT O, and engage the parking brake.
2. Shut of f the engine, remove the key , and wait
for all moving parts to stop before leaving the
operating position.
3. Push the motion-control levers down out of the
N EUTRAL - LOCK position ( Figure 69 ).
4. Check if the right motion-control lever aligns
horizontally with the left motion-control lever
( Figure 69 ).
g009436
Figure 69
1. Left motion-control lever 3. Check the horizontal
alignment here
2. Right motion-control lever
in the Neutral-lock position
4. Right motion-control lever
Note: T o adjust the right motion-control lever
horizontally , adjust the cam.
5. Release the cushion from the rear of the
machine.
6. Loosen the nut holding the cam ( Figure 70 ).
g031538
Figure 70
1. Cam
2. Nut
7. Adjust the cam until it aligns with the left
motion-control lever and tighten the nut for the
cam.
Note: Moving the cam clockwise (in the vertical
position) lowers the handle; moving the cam
counterclockwise (in the vertical position) raises
the handle.
Important: Ensure that the at portion of the
cam does not go above a vertical position
(right or left); otherwise you may damage the
switch.
8. Repeat steps 3 through 7 for the left
motion-control lever .
47
To Next Page
Loading...
