EasyManua.ls Logo

Toro Greensmaster 3150 04358 - Adjusting the Engine Speed; Replacing the Spark Plugs

Toro Greensmaster 3150 04358
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AdjustingtheEngineSpeed
Important:Beforeadjustingthecarburetorandspeed
control,adjustthethrottleandchokecontrols.
WARNING
Theenginemustberunningduringadjustment
ofthecarburetorandspeedcontrol.Contactwith
movingpartsorhotsurfacesmaycausepersonal
injury.
Shiftintoneutralandengagetheparkingbrake
beforeperformingthisprocedure.
Keephands,feet,clothing,andotherbodyparts
awayfromthecuttingblades,rotatingparts,the
mufer,andotherhotsurfaces.
1.Starttheengineandletitrunathalfthrottlefor
approximately5minutestowarmup.
2.MovethethrottlelevertotheSLOWsetting.Adjust
theidlestopscrewcounterclockwiseuntilitnolonger
contactsthethrottlelever.
3.Bendthegovernedidlespringanchortang(Figure50)
toattainanidlespeedof1550to1750rpm.Checkthe
speedwithatachometer.
Figure50
ShownwithAirCleanerRemoved
1.Governed
idle-spring-anchortang
2.High-speedspring-anchor
tang
4.Adjusttheidle-stopscrewclockwiseuntiltheidle
speedisanadditional25to50rpmovertheidlespeed
setinstep3
5.MovethethrottlelevertotheFASTposition.Bendthe
high-speedspring-anchortang(Figure50)toattaina
highspeedof2800to2900rpm.
ReplacingtheSparkPlugs
ServiceInterval:Every800hours
Therecommendedairgapis0.76mm(0.030inch)
ThecorrectsparkplugtouseisaChampionRC14YC.
Note:Thesparkplugusuallylastsalongtime;however,
removeandchecktheplugswhenevertheengine
malfunctions.
1.Cleantheareaaroundthesparkplugssoforeignmatter
cannotfallintothecylinder.
2.Pullthewiresoffofthesparkplugsandremovethe
plugs.
3.Checktheconditionofthesideelectrode,center
electrode,andcenterelectrodeinsulatortoensurethat
thereisnodamage.
Important:Replaceacracked,fouled,dirty,or
otherwisemalfunctioningsparkplug.Donotsand
blast,scrape,orcleanelectrodesbyusingawire
brushbecausegritmayeventuallyreleasefromthe
plug,fallintothecylinder,anddamagetheengine.
4.Settheairgapbetweenthecenterandsideofthe
electrodesat0.76mm(0.030inch)(Figure51).
Figure51
5.Installthecorrectly-gappedsparkplugwithagasket
seal,andtightentheplugto23N∙m(200in-lb).Ifyou
donothaveatorquewrench,tightentheplugrmly.
37

Table of Contents

Related product manuals