11. Apply a thin coat of Formetanch or Permatex No. 2
sealant to each end of the bearing housing at (Fig. 87,
Item a).
12. Apply MOLYKOTE G RAPID to the bearing surfaces
on t
he camshaft.
13. Install the camshaft (Item 3) with the DIST marking
at the timing gear end.
14. Install the camshaft bearing caps (Item 2) as shown
by cast-in markings.
15. Progressively tighten the bearing caps to 17.5 Nm
(13 ft-lb).
Figure 87
16. Install a new oil seal on tool TOR 976697 on the side
wher
e the inner flange is the farthest away (Fig. 88).
17. Use a camshaft gear or pulley bolt to install the two
camshaft oil seals.
TOR 976697
Figure 88
Groundsmaster 455-D Page 3 - 59
Rev
. B
Engine
Engine
To Next Page
Loading...
